Like with any building, an AR model needs to placed on a flat surface. This is an important step that's worth spending a little time getting right.
This How to will help you get the best out of using the Realar Places App and placing a model
- After selecting a model a bouncing red square will appear
- Using the red square slowly scan over a flat surface [1]
- Keep scanning backwards/forwards left/right until red square stops 'bouncing' and becomes solid
- Then simply tap where you would like the model placed (it will then % download if not done so already)
- A "dolls house" model will then appear together with the Trim Tools
NEXT: How to Adjust the Dolls House view and How to Go Real-Size
Protips
- If "drifting" happens, repeat from step #1 and pay special attention to scanning (even after red square goes solid)
- Low light can be problematic so use additional lighting (even using iPad as a flat surface)
- Be aware of slopes, drop-offs and any other site dangers
- Realar Places is limited to Smartphone GPS accuracy is limited to around 1m or 3ft (use survey pegs for building envelope placements)